Closner Equipment Co. Logo
RexCon LoGo 10S concrete batch plant
Back to Concrete Plants

RexCon Concrete Batch Plant

RexCon LoGo 10S Entry-Level Concrete Batch Plant

American-made entry-level transit-mix batch plant rated for 165-175 yards per hour. Gravity-feed 600 BBL cement storage with no screw conveyors, a 66 ton four-compartment aggregate bin, a 70 ft radial stacker, and CommandBATCH automation in one packaged plant.

Starting at$775,000

Capacity

100-200 yd/hr

Mix Type

Transit mix

Mobility

Mobile, stationary

Best For

Entering the Ready-Mix Business

RexCon LoGo 10S Entry-Level Concrete Batch Plant Overview

The RexCon LoGo 10S is the plant Closner recommends when a contractor or producer is getting into the ready-mix business and wants one straightforward, American-made package instead of a long options sheet. It pairs the proven LoGo 10 gravity-feed platform with a 600 BBL cement bin, a 30 in x 70 ft radial stacker, and CommandBATCH automatic batch controls with a moisture probe — including five days of start-up and training.

Gravity feed is the heart of the design. Cement moves from the hinged silo to the 10 yd3 cement batcher by gravity rather than screw conveyors, which means faster, more accurate batching with fewer wear parts and less maintenance. The 45 cu yd / 66 ton aggregate bin uses four equal in-line compartments, and load cells on both batchers keep material measurement precise.

Rated at 165 to 175 yards per hour, the LoGo 10S transports on a single trailer with a fifth wheel hitch, and the self-contained hinged cement section is pre-wired and pre-plumbed at the factory — so the plant works as a portable setup or a permanent stationary installation. Pricing starts at $775,000 for the complete package.

Plant Features

RexCon LoGo 10S Features That Matter on a Job Site

RexCon LoGo hinged gravity feed cement silo

Gravity Feed, No Screws

The hinged 600 BBL silo feeds the 10 yd3 cement batcher by gravity. Eliminating screw conveyors removes the single biggest maintenance headache on comparable plants and speeds up every batch.

RexCon LoGo 10S single trailer transport configuration

Single Trailer Transport

The whole plant moves as one trailer with a fifth wheel hitch, dual axles, eight wheels, brakes, and stop lights. Set up takes hours, not weeks.

RexCon LoGo 10S plant being erected on site

Portable or Stationary

The self-contained, hinged cement section is pre-wired and pre-plumbed at the factory, so the same plant works as a portable setup behind a paving spread or as a permanent ready-mix installation.

Key Features

Complete entry-level package starting at $775,000: plant, 30 in x 70 ft radial stacker with SC control and loading hopper, and CommandBATCH automation.

Gravity-feed cement storage and batching — no screw conveyors means reduced maintenance with faster, more accurate batching.

2,400 cu ft / 600 BBL / 112 ton CPMB-rated single-compartment gravity cement bin.

45 cu yd / 66 ton CPMB-rated aggregate bin with four equal in-line compartments.

10 yd3 aggregate and cement batchers with load cells; double clamshell aggregate discharge with inching control.

30 in batch transfer belt at 350 FPM with warning horn and emergency-stop pull cords on both sides.

CommandBATCH automatic batch controller with automatic moisture probe and five days of start-up and training.

Single-trailer transport with fifth wheel hitch; self-contained hinged cement section is factory pre-wired and pre-plumbed.

Technical Specifications

RexCon LoGo 10S Searchable Technical Specs

Searchable specifications for the RexCon LoGo 10S entry-level transit-mix concrete batch plant. The LoGo 10S pairs the proven LoGo 10 gravity-feed platform with a 600 BBL cement bin, a radial stacker, and CommandBATCH automation in a single packaged plant.

Entry-level portable transit-mix concrete batch plant

RexCon LoGo 10S

An American-made, entry-level dry-batch plant rated for 165 to 175 yards per hour, built around gravity-feed cement storage with no screw conveyors, a 66 ton four-compartment aggregate bin, 10 yd3 batchers on load cells, and single-trailer transport.

+
RexCon LoGo 10 dimension drawing showing aggregate bin, cement silo, batchers, and travel dimensions
RexCon LoGo 10 brochure and published LoGo 10S package specifications

Quick Specs

Production range
165 to 175 yards per hour rated production range.
Aggregate bins
45 cu yd, 66 ton (CPMB) aggregate bin with four equal in-line compartments. Optional 100 ton bin extension.
Cement storage
2,400 cu ft, 600 BBL, 112 ton (CPMB) single-compartment gravity-feed cement bin.
Transport
Single trailer with fifth wheel hitch. LoGo 10 brochure travel dimensions: 61 ft 6 in length, 13 ft 6 in height, 11 ft 9 in width.

Batching and Material Handling

Aggregate batcher
10 cu yd (CPMB) batcher, 3/16 in thick, with double clamshell discharge gate, dual air cylinders, and inching-type discharge control. Load cells with isolators assure precise measurement.
Cement batcher
10 cu yd (CPMB) batcher, 3/16 in thick, with atmospheric vent, cement aeration pads with adjustable flow control, and air-operated butterfly discharge gate.
Batch transfer belt
30 in wide batch belt at 350 FPM with start-up warning horn and emergency-stop pull cord on both sides.
Water system
3 in water meter with in-line strainer.
Radial stacker
30 in x 70 ft radial stacker with SC control and loading hopper (included in the LoGo 10S package).

Plant Systems

Air system
15 hp two-stage, constant-speed air compressor with 120 gallon tank, after-cooler, and auto-drain.
Electrical
UL-approved 460 volt power panel with starters for cement screws, batch belt, and air compressor motors, mounted on the plant, with 110V transformer.
Batch controls
CommandBATCH automatic batch controller with automatic moisture probe and five days of start-up and training included.
Platforms and access
Ladder from grade to top of base trailer, platform and handrails at top of base trailer, ladder to top of cement silo, and handrails around the silo top.

Transport and Options

Transportation
Dual axle with 8 wheels, brakes, and stop lights. King pin and connectors for fifth wheel transport.
Installation
Self-contained, hinged cement section, pre-wired and pre-plumbed at the factory, for portable or stationary installation.
Options
100 ton aggregate bin extension, auxiliary cement storage (550, 750, or 1,050 BBL), 36 in batch belt, high/low cement bin signals, AR steel or polyurethane liners, ladders and silo-top railings, and LPR-6 rooftop cartridge dust collector.

Specifications are based on the published RexCon LoGo 10S package and the RexCon LoGo 10 brochure. Final dimensions, options, controls, dust collection, and production rates vary by configuration; confirm the current submittal package with Closner before ordering or permitting.

When This Plant Is the Right Fit

First-time ready-mix producers who want one complete, supported package with controls and training included.

Contractors adding concrete supply to support their own paving, road, or commercial work.

Producers who value low maintenance — gravity feed eliminates cement screw conveyors entirely.

Operations that may relocate: single-trailer transport and hinged cement section keep moves practical.

Markets needing 165-175 yd/hr of transit-mix production without stepping up to a central-mix plant.

Texas Application

Texas ready-mix demand keeps growing along the I-35 corridor and across San Antonio, Austin, Dallas-Fort Worth, and Houston. The LoGo 10S gives a Texas start-up or expanding contractor a complete, CPMB-rated plant with automation and training in one purchase — and Closner backs it with parts, service, and plant support from right here in Texas.

RexCon LoGo 10S FAQ

How much does the RexCon LoGo 10S cost?

+

The RexCon LoGo 10S package starts at $775,000, including the 30 in x 70 ft radial stacker with loading hopper and the CommandBATCH automatic batch controller with moisture probe and five days of start-up and training. Contact Closner for a current quote with freight and installation for your Texas site.

What production rate does the LoGo 10S support?

+

The LoGo 10S is rated for a production range of 165 to 175 yards per hour as a transit-mix (dry batch) plant loading ready-mix trucks.

Why does gravity feed matter?

+

Gravity-feed cement storage eliminates screw conveyors between the silo and the cement batcher. That means faster, more accurate batching and noticeably less maintenance — there are simply fewer wear parts to service or replace.

Is the LoGo 10S portable?

+

Yes. The plant transports on a single trailer with a fifth wheel hitch, and the self-contained hinged cement section is pre-wired and pre-plumbed at the factory. It can be installed as a portable plant or set permanently as a stationary installation.

Can Closner support a first-time plant owner?

+

Yes. Closner helps with site planning, permitting support, erection, commissioning, operator training, parts, and ongoing service across Texas — and the LoGo 10S package itself includes five days of CommandBATCH start-up and training.

Compare Models

Related Concrete Batch Plants

Get In Touch

Whether you need a quote, service, or parts, our team is ready to assist you immediately.